Sussex Heat Care Logo

01243 841464

Factsheets - Water pressure

Whilst all advice given is correct to the best of our knowledge, we cannot be held responsible for any problems should you choose to take our advice.

Select from the following:


Insufficient pressure in an installation:

You need a pumped solution.

A Booster Set provides both high pressure and increased flow rates. A booster set contains a tank holding water for ten minutes of consumption and a pumo. The tank provides the volume of water to deal with the flow, the pump provides to pressure.

Low flow rate, but sufficient static pressure on the mains:

If you have enough pressure (we will ascertain this) you can use an accumulator which holds your cold water at the mains pressure with no power consumption, so the larger the better.

View our Factsheets on the following related topics:

Power Showering in Flats
Pressure and Stored Hot water
Flow and Pressure

Untitled Page

Registered Office

The Vineyard

Sidlesham Common


PO20 7QA
01243 841464

Untitled Page
Warm Front Logo
Vaillant Logo
Checkatrade Logo

Trading Standards
Gas Safe Logo